Physics 2025 Oct/Nov | Past Paper

Q1

Short Answer 1 mark

Scientists are investigating the variation in air pressure at different locations on a mountain.

Q1(a)

Short Answer 2 marks

The scientists take measurements of several physical quantities at each location. Complete Table 1.1 by stating the SI base unit for each quantity and identifying with a tick (3) whether each quantity is a scalar or a vector. Use the space for any working. Table 1.1 quantity measured SI base unit scalar vector air temperature air pressure

Q1(b)

Short Answer 2 marks

(i) At one location, the density of the air is 1.1 kg m . A spherical weather balloon is filled with a gas and released from rest. The balloon has radius 0.90 m. Calculate the upthrust acting on the balloon when it is released. upthrust = N

Q1(ii)

Short Answer 1 mark

Explain why an upthrust acts on the balloon.

Q1(iii)

Short Answer 3 marks

The balloon has weight 19 N. Calculate the magnitude of the initial acceleration of the balloon. acceleration = m s

Q1(c)

Short Answer 1 mark

A quantity c relating to the motion of the balloon is calculated from three measured quantities k, F and v using the formulac = 2kF The percentage uncertainties in the measured quantities are given in Table 1.2. Table 1.2 measured quantity percentage uncertainty k 5% F 3% v 4% The calculated value of c is 1.8. Determine the absolute uncertainty in c. absolute uncertainty = [2] [Total: 11] * 0000800000005 *

Q2

Short Answer 1 mark

A spacecraft in deep space uses jets of hot gas from its thrusters to change its velocity . Fig. 2.1 shows a side view of the spacecraft and some of its thrusters. upwards thruster B thruster A thruster C 0.40 m centre of gravity 1.6 m leftwards Fig. 2.1 (not to scale) Thruster A is a distance of 1.6 m leftwards from the centre of gravity of the spacecraft. Thruster C is a distance of 0.40 m upwards from the centre of gravity of the spacecraft. Thrusters A and B can produce forces on the spacecraft in the upwards direction only. Thruster C can produce a force on the spacecraft in the leftwards direction only . All the thrusters shown produce forces entirely in the same plane as the centre of gravity .

Q2(a)

Short Answer 2 marks

(i) Thruster A is activated, producing a force of 60 N upwards on the spacecraft. Thruster C is also activated, producing a force of 220 N in the leftwards direction on the spacecraft. Calculate the resultant moment due to these forces about the centre of gravity. resultant moment = N m

Q2(ii)

Short Answer 1 mark

State and explain whether the forces from A and C are a couple.

Q2(b)

Short Answer 1 mark

Thrusters A and C are now switched of f and the spacecraft is stationary . Thruster B is activated at time t , producing a constant force on the spacecraft until the fuel runs out at time . As the fuel is used, the total mass of the spacecraft decreases. On Fig. 2.2, sketch the variation of speed of the spacecraft with time from t to t speed time [2] * 0000800000007 *

Q2(c)

Short Answer 1 mark

The spacecraft now splits apart into a carrier and a payload as shown in Fig. 2.3. upwards carrier payload During the split, an average force of 5500 N acts on the payload for a time of 0.36 s. The velocity of the payload increases by 8.5 m s in the upwards direction. The combined mass of the carrier and payload is 2.5 × 10kg.

Q2(i)

Short Answer 1 mark

State the principle of conservation of momentum.

Q2(ii)

Short Answer 1 mark

Show that the mass of the payload is 230 kg. [2] * 0000800000008 *

Q2(iii)

Short Answer 1 mark

Calculate the magnitude of the change in velocity of the carrier. change in velocity = m s [3] [Total: 12] * 0000800000009 *

Q3

Short Answer 1 mark

A spring is fixed at one end and attached to the frame of a pulley at the other end. A cable is passed around the wheel of the pulley . The spring is stretched to a fixed length using the cable and pulley. Fig. 3.1 shows the view from above of the spring, cable and pulley . spring fixed end pulley frame pulley wheel cable The spring obeys Hooke' s law and has a spring constant k of 250 N m . A force F acts on the spring. The tension in the cable is T. The pulley is in equilibrium.

Q3(a)

Short Answer 2 marks

On Fig. 3.2, draw labelled arrows to show the directions of the forces acting on the pulley .

Q3(b)

Short Answer 1 mark

The force F is 1 10 N.

Q3(i)

Short Answer 1 mark

Determine T. T = N [1] * 0000800000010 *

Q3(ii)

Short Answer 2 marks

Calculate the extension of the spring. extension = m

Q3(c)

Short Answer 1 mark

A second identical spring with the same spring constant of 250 N m is now also connected to the pulley, as shown in Fig. 3.3. springs fixed end The tension in the cable is kept the same. The pulley is again in equilibrium.

Q3(i)

Short Answer 2 marks

Determine the extension of the springs. extension = m

Q3(ii)

Short Answer 1 mark

The elastic potential energy stored in the spring in Fig. 3.1 is E . The total elastic potential energy stored in the two springs in Fig. 3.3 is E Calculate the ratio ratio = [2] [Total: 9] * 0000800000011 *

Q4

Short Answer 1 mark

A laser emits visible light of a single frequency in a vacuum. The light is incident normally on a double slit and then forms a pattern of bright and dark fringes on a screen, as shown in Fig. 4.1. double slit screen dark fringe bright fringe fringe pattern on screen light 1.0 × 10 4.8 m 3.3 mm Fig. 4.1 (not to scale) The separation of the slits is 1.0 × 10 m. The distance from the slits to the screen is 4.8 m. The distance between the centres of adjacent dark fringes on the screen is 3.3 mm.

Q4(a)

Short Answer 1 mark

Explain how the pattern of bright and dark fringes is formed.

Q4(b)

Short Answer 1 mark

Calculate the frequency of the light emitted by the laser . frequency = Hz [4] * 0000800000012 *

Q4(c)

Short Answer 1 mark

The double slit is removed. A second laser is placed beside the first laser . The second laser produces visible light of a dif ferent frequency from that of the first laser . The beams of light from the two lasers overlap on the screen. Explain why a steady pattern of bright and dark fringes is not formed on the screen. [Total: 8] * 0000800000013 *

Q5

Short Answer 1 mark

Fig. 5.1 shows a circuit containing a battery , two fixed resistors X and Y, and a light-dependent resistor (LDR) Z. 100 Ω 4.7 Ω 5.0 V The battery has electromotive force (e.m.f.) 5.0 V and internal resistance 4.7 Ω. The current in X is and the current in Y is I The resistance of X is 100 Ω. The resistance of Z varies with the intensity of light incident on it as shown in Fig. 5.2. 0 50 100 intensity / W m resistance / Ω 150 200 250 Fig. 5.2 * 0000800000014 *

Q5(a)

Short Answer 1 mark

State Kirchhoff's first law.

Q5(b)

Short Answer 1 mark

The intensity of light incident on Z is 130 W m . The current in the battery is 38 mA.

Q5(i)

Short Answer 2 marks

Show that the terminal potential difference of the battery is 4.8 V.

Q5(ii)

Short Answer 3 marks

Calculate the current I in Y. = A

Q5(iii)

Short Answer 2 marks

Calculate the power dissipated in Y. power = W

Q5(iv)

Short Answer 1 mark

The intensity of the light incident on Z decreases. State and explain the effect on the terminal potential difference of the battery. [Total: 11] * 0000800000015 * To avoid the issue of disclosure of answer-related information to candidates, all copyright acknowledgements are reproduced online in the Cambridge Assessment International Education Copyright Acknowledgements Booklet. This is produced for each series of examinations and is freely available to download at www.cambridgeinternational.org after the live examination series.

Q6(a)

Short Answer 1 mark

State what is meant by a fundamental particle.

Q6(b)

Short Answer 1 mark

(i) Particle Q is a meson with a charge of 0. Determine a possible quark composition for Q.

Q6(ii)

Short Answer 3 marks

Particle Q has a mass of 0.67 u and a kinetic energy of 2.1 × 10-16 Calculate the speed of particle Q. speed = m s

Q6(c)

Short Answer 1 mark

Radium-228 ( 88Ra) is a radioactive nuclide.

Q6(i)

Short Answer 1 mark

State the number of electrons in a neutral atom of radium-228. number of electrons =

Q6(ii)

Short Answer 1 mark

A nucleus of radium-228 undergoes a series of decays to form nucleus X. During the process, 5 α-particles and 4 β particles are emitted. Determine the number of protons and the number of neutrons in nucleus X. number of protons = number of neutrons = [2] [Total: 9] * 0000800000016 *

Board	CAIE
Level	A Level
Subject	Physics
Code	`9702`
Year	2025
Session	Oct/Nov
Q&A	39 questions

Physics 2025 · Oct/Nov

Questions & Model Answers 39 Qs

Paper Details